新聞資訊

首頁>>新聞資訊

正確的使用挖掘機加長臂要注意什么?

日期:2024-01-29   來源:http://www.mjcafe.net/

(1)每次使用時,應檢查挖掘機加長臂高壓或低壓油管是否有松動現象;同時,為小心起見,應隨時檢查其他地方是否漏油,以免因振動造成油管脫落,從而發生故障。

(1) Before each use, first check whether the high-pressure or low-pressure oil pipes of the excavator's extended arm are loose; Meanwhile, as a precautionary measure, it is important to check for oil leaks in other areas at all times to avoid oil pipe detachment caused by vibration and potential malfunctions.

(2)當破碎特別堅硬的物體時,應先從邊緣處開始,不要在同一點上連續敲打超過1min,以防止釬桿燒毀或液壓油過熱。

(2) When crushing particularly hard objects, start from the edge and do not continuously strike at the same point for more than 1 minute to prevent the drill rod from burning or hydraulic oil from overheating.

20180403023805166

(3)不要用挖掘機加長臂的護板作為推動重物的工具,由于挖掘裝載機均以小型機為主,其本身重量輕,若以其推重物時,輕則損傷破碎錘,重則造成主機吊臂斷裂,甚發生主機翻車事故。

(3) Do not use the extended arm guard of an excavator as a tool to push heavy objects. As excavators and loaders are mainly small machines, their own weight is light. If they are used to push heavy objects, it can damage the crushing hammer lightly, cause the main crane arm to break, and even cause the main engine to overturn.

(4)在使用挖掘機加長臂進行破碎作業時,釬桿應始終與被破碎物體的表面保持垂直狀態。并使釬桿緊壓被破碎的物體,破碎后應立即停止破碎錘工作,以防止空打。持續漫無目標的沖擊會造成破碎錘的前體受損及主體螺栓松動,嚴重時可傷及主機本身。

(4) When using an excavator with an extended arm for crushing operations, the drill rod should always be perpendicular to the surface of the object being crushed. And make the drill rod tightly press the broken object, and immediately stop the work of the crushing hammer after crushing to prevent empty hitting. Continuous aimless impact can cause damage to the front body of the crushing hammer and loosening of the main bolts, and in severe cases, it can harm the host itself.

(5)進行破碎作用時,勿以搖晃釬桿使用,否則主體螺栓與釬桿均有破裂的可能;勿使破碎錘快速墜下或重擊在堅硬的石塊上,這樣會因受過度沖擊而損壞挖掘機加長臂。

(5) When performing crushing, do not shake the drill rod, otherwise both the main bolt and the drill rod may break; Do not let the hammer fall quickly or hit hard stones, as it may damage the excavator's extended arm due to excessive impact.

(6)勿在水中或泥濘地中進行破碎作業,除釬桿外,挖掘機加長臂的其他部分均不宜浸在水或泥濘中,否則其上的活塞及其他功能相近的零件會因堆積泥漬而造成破碎錘過早損耗。

(6) Do not carry out crushing operations in water or mud. Except for the drill rod, other parts of the excavator's extended arm should not be immersed in water or mud, otherwise the piston and other parts with similar functions on it will cause premature wear and tear of the crushing hammer due to the accumulation of mud stains.

【本站圖片均由網站所有方提供,部分圖片來源于網絡,如無意中侵犯了某媒體或個人的知識產權,請來信或來電告之,本網站將立即刪除?!?/p> 哦┅┅快┅┅用力啊┅┅电影